ip slb probe
Configures a Server Load Balancing (SLB) probe used to check the health of servers or clusters.
ip slb probe probe_name {ftp | http | https | imap | imaps | nntp | ping | pop | pops | smtp | tcp | udp}
no ip slb probe probe_name
Syntax Definitions
probe_name
ftp
http
https
imap
imaps
nntp
ping
pop
pops
smtp
tcp
udp
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to delete an SLB probe.
•
It is possible to configure up to 20 probes per switch.
Examples
-> ip slb probe mail_server_probe smtp
-> no ip slb probe mail_server_probe
page 26-16
Specifies the name of the Server Load Balancing (SLB) probe.
Specifies an FTP probe.
Specifies an HTTP probe.
Specifies an HTTPS probe.
Specifies an IMAP probe.
Specifies an IMAPS probe.
Specifies an NNTP probe.
Specifies a ping probe.
Specifies a POP probe.
Specifies a POPS probe.
Specifies an SMTP probe.
Specifies a TCP probe.
Specifies a UDP probe.
Server Load Balancing Commands
OmniSwitch CLI Reference Guide
June 2012