IS-IS Commands
ip isis level wide-metrics-only
Enables the wide metrics in LSPs for specific IS-IS levels.
ip isis level {1 | 2} wide-metrics-only
no ip isis level {1 | 2} wide-metrics-only
Syntax Definitions
1
2
Defaults
By default, wide metrics is disabled.
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to restore the narrow metric (1–63).
•
Wide metrics are used for improved granularity of metrics.
•
Numeric values above 63 indicate wide metrics.
Examples
-> ip isis level 1 wide-metrics-only
-> no ip isis level 1 wide-metrics-only
Release History
Release 6.2.1; command was introduced.
Related Commands
show ip isis status
MIB Objects
vRtrIsisLevelTable
VrtrIsisLevelWideMetricsOnly
OmniSwitch CLI Reference Guide
Specifies the IS-IS level as Level-1.
Specifies the IS-IS level as Level-2.
Displays the IS-IS status.
June 2012
page 24-33