Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1711

BGP Commands
output definitions
Sta
Prefix
Nbr Address
(0)
degPref
-> show ipv6 bgp path ipv6-addr 2020:100:200:1::/64
BGP Path parameters
Path address = 2020:100:200:1::
Path Length = 64
Path protocol = ibgp
Path neighbor = peer(2001:100:3:4::1)
Path nextHop
Path origin
Path local preference
Path state
Path weight
Path preference degree
Path autonomous systems = [nAs=0] : <none>,
Path MED
Path atomic
Path AS aggregator
Path IPaddr aggregator
Path community
Path Originator Id
Path Cluster List
Path unknown attribute
output definitions
Path address
Path Length
OmniSwitch CLI Reference Guide
Status flag.
">" Best Path: Indicates this is the best route to the destination.
"F" Feasible: The alternate path available when the best path goes
down.
"S" Stale: Indicates the peer that advertised this route's next hop is in
the process of graceful restart.
"P" Policy Changing: Indicates that a policy being applied may change
the route.
"U" Unsynchronized: Making a path unfeasible forcefully when a
nexthop is not reachable or if the local bgp network is deleted."
"D" Dampened: Indicates that this route is being dampened to prevent
flapping.
"N" None: No path available.
The destination address of the IPv6 route in the hexadecimal format.
The IP or IPv6 address of the BGP peer that advertises this path.
The origin attribute of this route path. A question mark (?) indicates
incomplete, and i indicates IGP, and an e indicates EGP.
The local preference value assigned to this route path.
= 2001:100:3:4::1,
= igp,
= 100,
= active,
= 0,
= 100,
= <none>,
= no,
= <none>,
= <none>,
= <none>,
= <none>,
= <none>,
= <none>
The IPv6 address for route path.
The prefix length of the IPv6 path.
June 2012 page 25-199