Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2078

stub
Defaults
parameter
hello-interval seconds
triggered-hello seconds
joinprune-interval seconds
hello-holdtime seconds
joinprune-holdtime seconds
prune-delay milliseconds
override-interval milliseconds
dr-priority priority
prune-limit-interval seconds
graft-retry-interval seconds
stub
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to delete an IPv6 PIM interface.
•
IPv6 PIM must be enabled globally on the switch before IPv6 PIM will begin running on the interface.
To globally enable or disable IPv6 PIM-SM on the switch, refer to the
command on page
dense status command on page
•
Specifying zero for IPv6 PIM hello-interval represents an infinite time, in which case the periodic IPv6
PIM hello messages are not sent.
•
Specifying zero for IPv6 PIM joinprune-interval represents an infinite time, in which case the periodic
IPv6 PIM joinprune messages are not sent.
•
Specifying the value of 65535 for IPv6 PIM hello-holdtime represents an infinite time. If an IPv6 PIM
router gets IPv6 PIM Hello packet from a neighbor with its hello-holdtime value as infinite time, then
the router will not time out the sender(neighbor). It is recommended that you use an IPv6 PIM hello-
holdtime interval that is 3.5 times the value of the IPv6 PIM hello-interval, or 65535 seconds if the
IPv6 PIM hello-interval is set to zero
•
Specifying the value of 65535 for IPv6 PIM joinprune-holdtime represents an infinite time. The receipt
of IPv6 Join/Prune messages with its joinprune-holdtime value as infinite time, then this specifies an
infinite holdtime for the particular IPv6 join/prune message. It is recommended that you use a join-
prune- holdtime interval that is 3.5 times the value of the IPv6 PIM Join/Prune interval defined for the
interface, or 65535 seconds if the IPv6 PIM joinprune-interval is set to zero.
page 30-90
Specifies the interface not to send any IPv6 PIM packets via this inter-
face, and to ignore received IPv6 PIM packets.
default
30
5
60
105
210
500
2500
1
60
3
Disabled
30-75. To enable or disable IPv6 PIM-DM on the switch, refer to the
30-76.
ipv6 pim sparse status
OmniSwitch CLI Reference Guide
PIM Commands
ipv6 pim
June 2012