Show Ip Pim Candidate-Rp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

PIM Commands

show ip pim candidate-rp

Displays the IP multicast groups for which the local router advertises itself as a Candidate-RP.
show ip pim candidate-rp
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
N/A
Examples
-> show ip pim candidate-rp
RP Address
------------------+---------------+---------+---------+--------
172.21.63.11
output definitions
RP Address
Group Address
Priority
Interval
Status
Release History
Release 6.3.1; command was introduced.
OmniSwitch CLI Reference Guide
Group Address Priority
224.0.0.0/4 192
A 32-bit IP address that is advertised as the Candidate-Rendezvous
Point (RP).
The 32-bit IP address for a multicast group, along with the mask length,
shown in bits. The group IP address and mask are separated by a slash
( / ). This is the group for which the local router advertises itself as a
C-RP.
The C-RP router's priority. The lower the value, the higher the priority.
The time interval at which the C-RP advertisements are sent to the
BSR.
The current status of this entry. The status is shown as enabled only if
the PIM-SM is globally enabled and the PIM interface is enabled.
June 2012
Interval Status
60 enabled
page 30-49