Table of Contents
Advertisement
Configuring IP Multicast Switching
Configuring IPMSv6 on a Switch
This section describes how to use Command Line Interface (CLI) commands to enable and disable IPv6
Multicast Switching (IPMSv6) switch wide (see
page
20-23), configure a port as an MLD static neighbor (see
Neighbor" on page
20-25), configure a port as an MLD static querier (see
MLD Static Querier" on page
Removing an MLD Static Group" on page
Note. See the "IP Multicast Switching Commands" chapter in the OmniSwitch CLI Reference Guide for
complete documentation of IPMSv6 CLI commands.
Enabling and Disabling IPv6 Multicast Status
IPv6 Multicast is disabled by default on a switch. The following subsections describe how to enable and
disable IPv6 Multicast by using the
Note. If IPv6 Multicast switching and routing is enabled on the system, the VLAN configuration
overrides the configuration of the system.
Enabling IPv6 Multicast Status
To enable IPv6 Multicast switching and routing on the system if no VLAN is specified, use the
ip multicast helper-address
-> ipv6 multicast admin-state enable
You can also enable IPv6 Multicast switching and routing on the specified VLAN by entering:
-> ipv6 multicast vlan 2 admin-state enable
Disabling IPv6 Multicast Status
To disable IPv6 Multicast switching and routing on the system if no VLAN is specified, use the
ip multicast helper-address
-> ipv6 multicast admin-state disable
Or, as an alternative, enter:
-> ipv6 multicast admin-state
To restore the IPv6 Multicast status to its default setting.
You can also disable IPv6 Multicast on the specified VLAN by entering:
-> ipv6 multicast vlan 2 admin-state disable
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 admin-state
To restore the IPv6 Multicast status to its default setting.
OmniSwitch AOS Release 7 Network Configuration Guide
"Enabling and Disabling IPv6 Multicast Status" on
20-26), and configure a port as an MLD static group (see
20-26)
ip multicast helper-address
command as shown below:
command as shown below:
March 2011
Configuring IPMSv6 on a Switch
"Configuring and Removing an MLD Static
"Configuring and Removing an
command.
"Configuring and
page 20-23
Advertisement
Table of Contents
