Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1451

IS-IS Commands
•
If the encrypt-key parameter is used to configure the password through the CLI, then its value should
be the same as the one that appears in the configuration snapshot. Only valid system generated values
are accepted as encrypt-key.
•
This command overrides the global configuration of IS-IS authentication type.
•
This command also sets the password or hash-key according to the type of authentication.
•
By default, the authentication is disabled and no authentication type is configured.
Examples
-> ip isis level 2 auth-type simple key rachel
-> ip isis level 2 auth-type md5 encrypt-key 7a1e441a014b4030
Release History
Release 6.2.1; command was introduced.
Release 6.3.1; key and encrypt-key parameters were added.
Related Commands
ip isis auth-type
show ip isis status
MIB Objects
vRtrIsisLevelTable
vRtrIsisLevelAuthType
vRtrIsisLevelAuthKey
OmniSwitch CLI Reference Guide
Enables authentication and configures the authentication type of IS-
IS protocol globally.
Displays the IS-IS status.
June 2012 page 24-29