Ipv6 Pim Interface - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

PIM Commands

ipv6 pim interface

Enables IPv6 PIM and configures the statistics such as hello-interval, triggered-hello, hello-holdtime, join-
prune, prune-delay, override-interval, dr-priority, stub interface, prune limit interval, and graft retry inter-
val on the IPv6 interface.
ipv6 pim interface if_name [hello-interval seconds] [triggered-hello seconds] [joinprune-interval
seconds] [hello-holdtime seconds] [joinprune-holdtime seconds] [prune-delay milliseconds] [override-
interval milliseconds] [dr-priority priority] [[no] stub] [prune-limit-interval seconds] [graft-retry-
interval seconds]
no ipv6 pim interface if_name
Syntax Definitions
if_name
hello-interval seconds
triggered-hello seconds
joinprune-interval seconds
hello-holdtime seconds
joinprune-holdtime seconds
prune-delay milliseconds
override-interval milliseconds
dr-priority priority
prune-limit-interval seconds
graft-retry-interval seconds
OmniSwitch CLI Reference Guide
The interface name on which the IPv6 PIM is being enabled or disabled.
The frequency at which IPv6 PIM Hello messages are transmitted on
this interface, in seconds. Values may range from 0 to 18000.
Specifies the maximum time, in seconds, before a triggered IPv6 PIM
Hello message is sent on this interface. Values may range from 0 to 60.
The frequency at which periodic IPv6 PIM Join/Prune messages are sent
on this interface, in seconds. Values may range from 0 to 18000.
Specifies the value of the IPv6 PIM hello-holdtime for this interface.
This value is set in the Holdtime field of IPv6 PIM Hello messages sent
on this interface, in seconds. Values may range from 0 to 65535.
Specifies the value that is set in the Holdtime field of the IPv6 PIM
Joinprune messages sent on this interface, in seconds.Values may range
from 0 to 65535.
Specifies the value of the expected propagation delay between IPv6
PIM routers on this network, inserted into the LAN prune-delay option
of the IPv6 PIM Hello messages sent on this interface, in milliseconds.
Values may range from 0 to 32767.
Specifies the value set in the Override Interval field of the LAN prune-
delay option of the IPv6 PIM Hello messages sent on this interface, if
the prune-delay status is enabled, in milliseconds. Values may range
from 0 to 65535.
Specifies the Designated Router priority set in the DR priority option on
this interface. The DR priority option value (1–192). A higher numeric
value denotes a higher priority.
Specifies the minimum interval that must elapse between two succes-
sive IPv6 PIM prune messages sent on this interface, in seconds. Values
may range from 0 to 65535.
Specifies the minimum interval that must elapse between two succes-
sive IPv6 PIM graft messages sent on this interface, in seconds. Values
may range from 0 to 65535.
June 2012 page 30-89