Ip Ospf Area - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip ospf area

Assigns an OSPF interface to a specified area.
ip ospf area area_id [summary {enable | disable}] | [type {normal | stub | nssa}]
no ip ospf area area_id
Syntax Definitions
area_id
enable
disable
normal
stub
nssa
Defaults
parameter
enable | disable
normal | stub | nssa
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
The no form deletes the area.
•
The summary options are used to enable or disable route summarization for stub and NSSA areas.
Stub and NSSA areas will not receive LSA type 3 unless summary is enabled.
•
The type command allows you to chose what type of area this is going to be.
Examples
-> ip ospf area 0.0.0.1
-> ip ospf area 0.0.0.1 type stub
-> ip ospf area 0.0.0.1 type normal
-> no ip ospf area 0.0.0.1
Release History
Release 6.1; command was introduced.
page 22-20
A unique 32-bit value in IP address format.
Enables summarization.
Disables summarization.
Sets the area as a regular OSPF area.
Configures an OSPF area as a stub area.
Configures an OSPF area as a Not So Stubby Area (NSSA)
default
enable
normal
OmniSwitch CLI Reference Guide
OSPF Commands
June 2012