Ip Bgp Policy Route-Map - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

BGP Commands

ip bgp policy route-map

Creates or deletes a policy route map.
ip bgp policy route-map name sequence_number
Syntax Definitions
name
sequence_number
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command creates policy route maps. Each route map can be configured using the following match
commands to specify the match criteria by which routes are allowed to pass. Match criteria is exam-
ined in the order the commands are listed below.
1. ip bgp policy route-map aspath-list
2. ip bgp policy route-map prefix-list
3. ip bgp policy route-map community-list
4. ip bgp policy route-map match-regexp
5. ip bgp policy route-map match-prefix
6. ip bgp policy route-map match-mask
7. ip bgp policy route-map match-community
•
Each route map can also be configured using the following set commands to sequentially specify the
actions to be taken when a match is found.
•
ip bgp policy route-map community
•
ip bgp policy route-map community-mode
•
ip bgp policy route-map lpref
•
ip bgp policy route-map lpref-mode
•
ip bgp policy route-map med
•
ip bgp policy route-map med-mode
•
ip bgp policy route-map origin
OmniSwitch CLI Reference Guide
Route map name. Case-sensitive.
Route map sequence number in the range of 1 to 255. The sequence
number allows for multiple instances of the same route map name.
June 2012 page 25-121