Qos Port Monitor - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

qos port monitor

Enables or disables the gathering of transmit and drop packet statistics for the egress queues of the speci-
fied port.
qos port slot/port monitor
qos port slot/port no monitor
Syntax Definitions
slot/port
Defaults
By default, monitoring is disabled for the port.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855
Usage Guidelines
•
Use the no form of this command to disable QoS statistics monitoring for the specified port.
•
Enabling QoS statistics monitoring resets all statistics counters for the port. At such point in time,
statistics gathering is started and continues until the monitoring is disabled and enabled again or statis-
tics are reset using the
•
QoS statistics monitoring is allowed only on one port per slot at any given time.
•
Use the show qos queue
•
Enabling QoS port monitoring is required to capture statistics on a per port basis. Note that this
command is not required on the OmniSwitch 9000E, as QoS monitoring is automatically active on all
ports for these switches.
Examples
-> qos port 1/10 monitor
-> qos port 2/2 monitor
-> qos port 1/10 no monitor
-> qos port 2/2 no dei egress
Release History
Release 6.4.3; command was introduced.
page 32-64
The slot number and port number of the physical port.
qos stats reset command.
command to display statistics for QoS monitored ports.
OmniSwitch CLI Reference Guide
QoS Commands
June 2012