Ip Dvmrp Tunnel - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip dvmrp tunnel

Adds or deletes a DVMRP tunnel.
ip dvmrp tunnel {local_name} {remote_address}
no ip dvmrp tunnel {local_name} {remote_address}
Syntax Definitions
local_name
remote_address
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to delete a tunnel.
•
The local IP address of the tunnel must match the IP address of an existing DVMRP interface.
•
Routing (via RIP, OSPF, etc.) must first be set up in order for the remote tunnel endpoint to be
accessible.
Examples
-> ip dvmrp tunnel vlan-2 168.22.2.120
-> no ip dvmrp tunnel vlan-2 168.22.2.120
-Release History
Release 6.1; command was introduced.
Release 6.1.1; local_address and remote_name parameters deprecated.
page 29-18
The name of the local router interface.
The 32-bit IP address of the remote router interface. The remote router
interface IP address serves as an identifier for the remote end of the
DVMRP tunnel.
OmniSwitch CLI Reference Guide
DVMRP Commands
June 2012