ip pim register-suppress-timeout
Specifies the period during which a Designated Router (DR) stops sending Register-encapsulated packets
to the Rendezvous Point (RP) after receiving a Register-Stop message.
ip pim register-suppress-timeout seconds
Syntax Definitions
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is supported in both IPv4 and IPv6 PIM.
•
This command is supported only in the sparse mode.
Examples
-> ip pim register-suppress-timeout 10
Release History
Release 6.1.1; command was introduced.
Related Commands
show ip pim sparse
show ipv6 pim sparse
MIB Objects
alaPim
alaPimRegisterSuppressionTime
page 30-24
The timeout value, in seconds (0–65535).
default
60
Displays the status of the various global parameters for the PIM
sparse mode.
Displays the status of the various global parameters for the IPv6
PIM sparse mode.
OmniSwitch CLI Reference Guide
PIM Commands
June 2012