Ip Bgp Policy Prefix-List - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip bgp policy prefix-list

Creates or deletes a prefix match list.
ip bgp policy prefix-list name ip_address ip_mask
no ip bgp policy prefix-list name ip_address ip_mask
Syntax Definitions
name
ip_address
ip_mask
Defaults
No IP BGP policy prefix-list exists.
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command creates prefix lists that can be applied to a peer's inbound and outbound routes using the
ip bgp neighbor in-prefixlist
routes based on one or more prefixes, as shown in the example below. If the route matches the prefix
list filter, according to the ge (lower) and le (upper) limits defined, then the permit or deny action
associated with the prefix applies.
•
General or more specific prefix list information can be displayed by varying the use of the
command.
Examples
-> ip bgp policy prefix-list prefixListA 12.0.0.0 255.0.0.0
Release History
Release 6.1; command was introduced.
page 25-112
Prefix list name.
IP address for the prefix list.
Mask for the prefix list.
and ip bgp neighbor out-prefixlist commands. The prefix list filters
OmniSwitch CLI Reference Guide
BGP Commands
show ip bgp
June 2012