Show Ip Dvmrp Debug - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip dvmrp debug

Displays the current level of debugging for DVMRP protocol on the switch, as well as the current status
for all debugging types.
show ip dvmrp debug
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
The administrative debugging status for message types displayed in the table are determined by the
ip dvmrp debug-type command on page
•
To configure debug levels, refer to the
Examples
-> show ip dvmrp debug
Debug Level = 1,
Error = on,
Flash = off,
Grafts = off,
IGMP = off,
IPMRM = off,
Init = off,
MIP = off,
Misc = off
Nbr = on,
Probes = off,
Prunes = off,
Routes = on,
Time = off,
TM = off,
output definitions
Debug Level
error
Flash
page 29-40
29-23.
ip dvmrp debug-level command on page
The current debug level value. For information on setting this parame-
ter, see the ip dvmrp debug-level command on page
The current debugging status for DVMRP Error messages. Options
include on or off.
The current debugging status for DVMRP Flash processing. Options
include on or off.
29-22.
OmniSwitch CLI Reference Guide
DVMRP Commands
29-22.
June 2012