Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1912

output definitions
Query Response Interval
(milliseconds)
Last Member Query Interval
(milliseconds)
Unsolicited Report Interval
(seconds)
Router Timeout (seconds)
Source Timeout (seconds)
Max-group
Max-group action
Release History
Release 6.1.1; command was introduced.
Release 6.3.1; Querier Forwarding field added.
Release 6.3.4; Max-group and Max-group action field added.
page 27-106
Displays the time (in milliseconds) to reply to an MLD query message.
(The default value is 10000 milliseconds.) You can modify this parame-
ter with the ipv6 multicast query-response-interval
is described on page 27-67.
Displays the time (in milliseconds) to reply to an MLD query message
sent in response to a leave group message. (The default value is 1000
milliseconds.) You can modify this parameter with the
ipv6 multicast last-member-query-interval
described on page 27-65.
Displays the time period (in seconds) to proxy any changed MLD
membership state. (The default value is 1 second). You can modify this
parameter with the ipv6 multicast unsolicited-report-interval
mand, which is described on
Displays the MLD router timeout in seconds (The default value is 90
seconds.) You can modify this parameter with the
ipv6 multicast router-timeout
27-71
Displays the IGMP source timeout in seconds (The default is 30 sec-
onds.) You can modify this parameter with the
ipv6 multicast source-timeout
27-73
The global or VLAN specific maximum group count allowed.
The action to be taken when the group membership limit is exceeded.
IP Multicast Switching Commands
command, which is
page 27-69.
command, which is described on
command, which is described on
OmniSwitch CLI Reference Guide
command, which
com-
page
page
June 2012