Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1419

Alcatel-lucent omniswitch 6850-48: reference guide
Hide thumbs Also See for OmniSwitch 6850-48:
Table of Contents

Advertisement

OSPFv3 Commands
-> show ipv6 ospf interface vlan-2071
Type
Admin Status
IPv6 Interface Status
Oper Status
State
Area
Priority
Cost
Designated Router
Backup Designated Router
Hello Interval
Router Dead Interval
Retransmit Interval
Transit Delay
Ifindex
IPv6 'ifindex'
MTU
# of attached neighbors
Globally reachable prefix #0
Output fields when an IP address or interface name is specified are described below:
output definitions
Type
Admin Status
IPv6 Interface Status
Oper Status
State
Area
Priority
Cost
Designated Router
Backup Designated Router
Hello Interval
Router Dead Interval
Retransmit Interval
Transit Delay
OmniSwitch CLI Reference Guide
= BROADCAST,
= Enabled,
= Up,
= Up,
= DR,
= 0.0.0.0,
= 100,
= 1,
= 3.3.3.3,
= 0.0.0.0,
= 1,
= 4,
= 5,
= 1,
= 17,
= 2071,
= 1500,
= 0,
= 2071::2/64
The OSPF interface type, which can be Broadcast, NBMA, Point-to-
Point, or Point-to-Multipoint.
The current administrative status of the interface, either enabled or
disabled.
The current administrative status of the IPv6 interface, either up or
down.
Indicates whether the interface is an active OSPF interface.
The current state of the OSPF interface. It will be down, up, dp, dr, or
other.
The area identification number to which the interface is assigned. This
field is not applicable if an interface has not yet been assigned to an
area.
The priority of the interface with regards to becoming the designated
router. The higher the number, the higher the priority.
The cost added to routes learned on this interface.
The identification number of the designated router.
The identification number of the backup designated router.
The number of seconds between hello messages sent out on the inter-
face.
The number of seconds the interface waits for hello messages received
from a neighbor before declaring the neighbor as dead.
The number of seconds the interface waits before resending hello mes-
sages.
The estimated number of seconds required to transmit a link state
update over this interface.
June 2012
page 23-43

Advertisement

Table of Contents
loading

Table of Contents