Ip Bgp Cluster-Id - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip bgp cluster-id

Configures a BGP cluster ID when there are multiple, redundant, route reflectors in a cluster. This
command is not necessary for configurations containing only one route reflector.
ip bgp cluster-id ip_address
Syntax Definitions
ip_address
Defaults
parameter
ip_address
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
In a route-reflection configuration where there are multiple route-reflectors in a cluster, use this
command to configure this cluster ID. Configuring multiple route-reflectors enhances redundancy and
avoids a single point of failure. When there is only one reflector in a cluster, the router ID of the reflec-
tor is used as the cluster-ID.
•
The BGP protocol must be disabled (using the
•
Using many redundant reflectors in a single cluster places demands on the memory required to store
routes for all redundant reflectors' peers.
Examples
-> ip bgp cluster-id 1.2.3.4
Release History
Release 6.1; command was introduced.
Related Commands
ip bgp status
ip bgp client-to-client reflection
MIB Objects
alaBgpGlobal
alaBgpClusterId
page 25-12
32-bit IP address that is the Cluster ID of the router acting as a route
reflector.
default
0.0.0.0
ip bgp status
Enables and disables BGP.
Enables route reflection and sets this speaker as the route reflector.
command) before using this command.
OmniSwitch CLI Reference Guide
BGP Commands
June 2012