Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1795

Server Load Balancing Commands
-> show ip slb clusters statistics
Cluster Name
-----------------------+--------+---------------------+--------
Cluster1
Cluster2
Cluster3
Cluster4
output definitions
Cluster Name
Count
Release History
Release 6.1; command was introduced.
Release 6.1.5; statistics parameter added; Count field added.
Related Commands
ip slb reset statistics
show ip slb cluster
show ip slb servers
show ip slb cluster server
MIB Objects
slbClusterTable
slbClusterName
slbClusterVIP
slbClusterCondition
slbClusterAdminStatus
slbClusterOperStatus
slbClusterNumberOfServers
slbClusterNewFlows
slbStatsTable
slbStatsClusterName
slbStatsIndex
slbStatsCounter
slbStatsQualTable
slbStatsQualType
slbStatsQualData
OmniSwitch CLI Reference Guide
Admin Operational
Status Status
Enabled In Service
Enabled In Service
Enabled In Service
Enabled In Service
The name of the SLB cluster. This field also contains the administrative
and operational status for the cluster and either the VIP address or QoS
policy condition value that identifies the cluster.
The total number of physical servers that belong to the cluster, and the
total number of packets serviced by the cluster.
Resets SLB statistics for all clusters.
Displays detailed status and configuration information for a single SLB
cluster.
Displays the status of all physical servers belonging to each SLB cluster
on a switch.
Displays detailed status and configuration information for a single phys-
ical server in an SLB cluster.
June 2012
Count
4 Servers
4 Servers
4 Servers
2 Servers
page 26-35