Chapter 33 Qos Policy Commands - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

33 QoS Policy Commands
This chapter describes CLI commands used for policy management in the switch. The Quality of Service
(QoS) software in the switch uses policy rules for classifying incoming flows and deciding how to treat
outgoing flows. A policy rule is made up of a policy condition and a policy action. Policy rules may be
created on the switch through CLI or SNMP commands, or they may be created through the PolicyView
GUI application on an attached LDAP server.
Note. Rules created through PolicyView cannot be modified through the CLI; however, you can create
policies in the CLI that take precedence over policies created through PolicyView.
Refer to Chapter 43, "QoS Commands,"
MIB information for the QoS policy commands is as follows:
Filename: alcatelIND1Qos.mib
Module ALCATEL-IND1-QoS-MIB
Important Note. Some of the commands listed here are not currently supported on one or more plat-
forms. See command descriptions in this chapter and check release notes for information about commands
that are not supported.
The QoS Policy commands are listed here:
Policy commands
OmniSwitch CLI Reference Guide
for information about commands used to configure QoS software.
policy rule
policy validity period
policy condition
policy action
policy list
show policy action
show policy condition
show active policy rule
show active policy rule meter-statistics
show policy rule
show policy validity period
show active policy list
show policy list
June 2012 page 33-1