Ipv6 Bgp Neighbor - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

BGP Commands

ipv6 bgp neighbor

Creates or deletes a BGP peer relationship using IPv6 addresses.
ipv6 bgp neighbor ipv6_address
no ipv6 bgp neighbor ipv6_address
Syntax Definitions
ipv6_address
Defaults
By default, no BGP peers are configured in the BGP network.
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to delete a BGP peer.
•
To establish a BGP session, the BGP peer should be reachable.
•
You must manually enable a BGP peer after creating it. A BGP peer is enabled using the
neighbor status command.
•
Once created, a BGP peer must be assigned an autonomous system number using the
bor remote-as command.
•
Use update-source keyword to configure the IPv6 interface when link-local address is used as neigh-
bor address.
Examples
-> ipv6 bgp neighbor 2001::1
-> no ipv6 bgp neighbor 2001::1
Release History
Release 6.1.5; command was introduced.
OmniSwitch CLI Reference Guide
The 128-bit IPv6 address of the new BGP peer.
June 2012
ipv6 bgp
ipv6 bgp neigh-
page 25-215