Ipv6 Ospf Interface Hello-Interval - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ipv6 ospf interface hello-interval

Configures the OSPFv3 interface hello interval.
ipv6 ospf interface interface_name hello-interval seconds
Syntax Definitions
interface_name
seconds
Defaults
parameter
seconds
(broadcast and point-to-point)
seconds
(NBMA and point-to-multi-
point)
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
This is the interval between two consecutive hello packets sent out on this interface.
Examples
-> ipv6 ospf interface vlan-101 hello-interval 50
Release History
Release 6.1.3; command was introduced.
Related Commands
ipv6 ospf interface dead-
interval
show ipv6 ospf interface
MIB Objects
ospfv3IfTable
ospfv3IfIndex
ospfv3IfHelloInterval
page 23-20
The name of the interface.
The hello interval, in seconds. The valid range is 0–65535. A value of 0
create a passive OSPF interface.
default
10
30
Configures the OSPFv3 interface dead interval.
Displays the status and statistics of an OSPFv3 interface.
OmniSwitch CLI Reference Guide
OSPFv3 Commands
June 2012