Ip Dvmrp Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

DVMRP Commands

ip dvmrp status

Globally enables or disables DVMRP protocol on the switch.
ip dvmrp status {enable | disable}
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command must be set to enable before DVMRP can run on the switch. In addition, the ip load
dvmrp command must be issued. For more information, refer to the
page 29-2.
•
The advanced routing image must be loaded before the DVMRP feature starts working on the switch.
•
To enable or disable DVMRP for a particular interface, refer to the
page 29-7.
Examples
-> ip dvmrp status enable
-> ip dvmrp status disable
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Administratively enables DVMRP on the switch.
Administratively disables DVMRP on the switch.
default
disable
June 2012
ip load dvmrp command on
ip dvmrp interface command on
page 29-3