Ip Bgp Aggregate-Address Local-Preference - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

BGP Commands

ip bgp aggregate-address local-preference

Configures the local preference attribute value for this BGP aggregate. This value will override the default
local preference value; it is used when announcing this aggregate to internal peers.
ip bgp aggregate-address ip_address ip_mask local-preference value
no ip bgp aggregate-address ip_address ip_mask local-preference value
Syntax Definitions
ip_address
ip_mask
value
Defaults
parameter
value
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to set the local preference back to the default value.
•
You can specify that this route use the default local preference value for the AS by specifying zero (0).
In this case the local preference for this route will take the default local preference value set for this AS
(defined in the ip bgp default local-preference
Examples
-> ip bgp aggregate-address 172.22.2.115 255.255.255.0 local-preference 200
-> no ip bgp aggregate-address 172.22.2.115 255.255.255.0 local-preference 200
Release History
Release 6.1; command was introduced.
Related Commands
ip bgp default local-preference
OmniSwitch CLI Reference Guide
An IP address for the aggregate route.
A 32-bit subnet mask that determines how many bits of the IP address
denote the network number.
The local preference attribute. The valid range is 0–4294967295
default
0
command).
Sets the default local preference value for this AS.
June 2012 page 25-39