Qos Port Maximum Egress-Bandwidth - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

qos port maximum egress-bandwidth

Configures the maximum rate at which to send traffic on the specified QoS port.
qos port slot/port maximum egress-bandwidth bps
qos port slot/port no maximum egress-bandwidth
Syntax Definitions
slot/port
bps
Defaults
By default, the maximum bandwidth is the maximum allowed for the interface type on which the port
resides.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a configured maximum egress bandwidth value from a
port.
•
The maximum egress bandwidth value cannot exceed the maximum bandwidth of the interface type
associated with the port.
•
Modifying the maximum egress bandwidth is most useful for low-bandwidth links.
Examples
-> qos port 3/1 maximum egress-bandwidth 1000
-> qos port 3/1 no maximum egress-bandwidth
Release History
Release 6.1; command was introduced.
Release 6.3.1; bandwidth parameter changed to egress-bandwidth.
Related Commands
qos port maximum ingress-
bandwidth
qos apply
qos port
show qos port
page 32-52
The slot number and port number of the physical port.
The maximum amount of bandwidth that may be used for all traffic
egressing on the QoS port.
Configures the rate at which traffic is received on a QoS port.
Applies configured QoS and policy settings to the current configuration.
Configures a physical port for QoS.
Displays information about QoS ports.
OmniSwitch CLI Reference Guide
QoS Commands
June 2012