show ipv6 ospf area
Displays either all OSPFv3 areas, or a specified OSPFv3 area.
show ipv6 ospf area [area_id]
Syntax Definitions
area_id
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Allows you to view the details of a specified OSPFv3 area.
•
If an OSPF area is not specified, all known areas for the OSPFv3 router will be displayed.
•
See the Related Commands section below for information on modifying an area.
Examples
-> show ipv6 ospf area
Area ID
----------------+-------+-------+-------------
0.0.0.0
0.0.0.1
-> show ipv6 ospf area 0.0.0.0
Area Type
Area Stub Metric
# of SPF calculations
# Interfaces
# Router LSAs
# Network LSAs
# Intra-area-prefix LSAs
# Inter-area-prefix LSAs
# Inter-area-router LSAs
# hosts
output definitions
Area Type
Area Stub Metric
# Router LSAs
page 23-40
A unique 32-bit value in IP address format.
Stub
Number of
Type
Metric
Interfaces
Normal
NA
2
Normal
NA
2
The area type. This field will be normal or stub.
Indicates whether the area is enabled or disabled.
The total number of Link State Advertisements for the Area.
= Normal,
= 0,
= 52,
= 3,
= 2,
= 3,
= 4,
= 15,
= 0,
= 0,
OmniSwitch CLI Reference Guide
OSPFv3 Commands
June 2012