Ip Bgp Policy Route-Map Lpref-Mode - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip bgp policy route-map lpref-mode

Configures the action to be taken when setting local preference attribute for a local matching route.
ip bgp policy route-map name sequence_number lpref-mode {none | inc | dec | rep}
Syntax Definitions
name
sequence_number
none
inc
dec
rep
Defaults
parameter
none | inc | dec | rep
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is used in conjunction with
the combined usage.
•
In this example, the local preference value is incremented for a matching route by 555.
Examples
-> ip bgp policy route-map routemap1 1 lpref-mode none
-> ip bgp policy route-map routemap1 1 lpref 555 lpref-mode inc
Release History
Release 6.1; command was introduced.
page 25-132
The route map name.
The route map sequence number. The valid range is 1–255.
Do not set the local preference attribute.
Increment the local preference attribute in the matching route by the
value specified in the ip bgp policy route-map med
action is taken if no local preference attribute is found in the matching
route.
Decrement the local preference attribute in the matching route by the
value specified in the ip bgp policy route-map med
action is taken if no local preference attribute is found in the matching
route.
Replace the local preference attribute in the matching route by the value
specified in the ip bgp policy route-map med
local preference attribute is found in the matching route.
default
none
ip bgp policy route-map
command. No
command. No
command even if no
lpref. The example below shows
OmniSwitch CLI Reference Guide
BGP Commands
June 2012