Show Ip Ospf Restart - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip ospf restart

Displays the OSPF graceful restart related configuration and status.
show ip ospf restart
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
The minimum hardware configuration for this command is a redundant CMM configuration. This
command is not supported on OmniSwitch chassis-based switches with a single CMM or OmniSwitch
stackable switches in a standalone configuration.
•
On OmniSwitch stackable switches, a graceful restart is supported only on active ports (i.e., interfaces)
that are on the secondary or idle modules in a stack during a takeover. It is not supported on ports on a
primary switch in a stack.
Examples
-> show ip ospf restart
Restart Support
Restart Interval (in seconds)
Restart Status
Restart Age (in seconds)
Last Restart Exit Reason
Restart Helper Support
Restart Helper Strict Checking
Restart Helper Mode
output definitions
Restart Support
Restart Interval
Restart Status
Restart Age
page 22-86
= Enabled,
= 120,
= Not Restarting,
= 0,
= None,
= Enabled,
= Enabled,
= NotHelping
The administrative status of OSPF graceful restart, which can be
Enabled or Disabled.
The configured OSPF hitless restart timeout interval, in seconds. Use
the ip ospf restart-interval
The current status of OSPF graceful restart, which can be Not Restart-
ing, Unplanned Restart (after a CMM takeover), or Planned Restart
(before CMM takeover).
The remaining time, in seconds, for the current OSPF graceful restart
interval.
command to modify this parameter.
OmniSwitch CLI Reference Guide
OSPF Commands
June 2012