Ipv6 Multicast Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IP Multicast Switching Commands

ipv6 multicast status

Enables or disables IPv6 Multicast Switching and Routing on the specified VLAN or on the system if no
VLAN is specified.
ipv6 multicast [vlan vid] status [{enable | disable}]
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
If an IPv6 multicast routing protocol is already running on the system, the ipv6 multicast status
command will override this configuration and always enable IPv6 Multicast Switching and Routing.
•
If the IPv6 Multicast Switching and Routing is already enabled on the system, then the VLAN configu-
ration will override the system's configuration.
•
You can also restore the MLD querying to its default (i.e., disabled) status on the system if no VLAN
is specified, by using only ipv6 multicast status (e.g., ipv6 multicast status).
•
You can also restore the MLD querying to its default (i.e., disabled) status on the specified VLAN, by
using only ipv6 multicast vlan vid status (e.g., ipv6 multicast vlan 2 status).
Examples
-> ipv6 multicast status enable
-> ipv6 multicast status disable
-> ipv6 multicast status
-> ipv6 multicast vlan 2 status enable
-> ipv6 multicast vlan 2 status disable
-> ipv6 multicast vlan 2 status
Release History
Release 6.1.1; command was introduced.
OmniSwitch CLI Reference Guide
VLAN on which to apply the configuration.
Enable IPv6 Multicast Switching and Routing.
Disable IPv6 Multicast Switching and Routing.
default
disable
June 2012 page 27-45