Policy Service Group - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

policy service group

Configures a service group and its associated services. The group may be used as part of a policy condi-
tion. The action associated with any policy using the condition will be applied to all members of the
service group.
policy service group service_group service_name1 [service_name2...]
no policy service group service_group
policy service group service_group no service_name1 [service_name2...]
Syntax Definitions
service_group
service_name1
service_name2...
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use this command to configure a group of services to which you want to apply QoS rules. Rather than
create a condition for each service, group services together. Use the policy condition command to
associate a condition with the service group.
•
Use the no form of the command to remove a service group from the configuration, or to remove a
service from a service group.
•
To drop packets destined to specific TCP and UDP ports, create port services for the traffic that you
want dropped and add these services to a service group called DropServices. Then create a condition
for this service group and a source port group, which can then be used in a deny rule. Refer to the
OmniSwitch AOS Release 6 Network Configuration Guide for more information about ACL security
enhancements.
•
If the snapshot command is entered after the policy service group command is configured, the result-
ing ASCII file will include the following additional syntax for the policy service group command:
from {cli | ldap | blt}
This syntax indicates how the service group was created. The cli and ldap options may be changed by
a user modifying the ASCII file; however, changing this setting is not recommended. The blt option
indicates a built-in service group, this setting is not configurable.
OmniSwitch CLI Reference Guide
The name of the service group (up to 31 alphanumeric characters).
The service name is configured through the policy service command
and includes information about protocol, source port, and destination
port.
Optional. Additional service names may be configured for a service
group. Separate each service name with a space.
June 2012 page 33-19