Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1681

BGP Commands
-> show ip bgp neighbors 0.0.0.1
Neighbor address
Neighbor autonomous system
Neighbor Admin state
Neighbor Oper state
Neighbor passive status
Neighbor name
Neighbor local address
Neighbor EBGP multiHop
Neighbor next hop self
Neighbor Route Refresh
Neighbor Ipv4 unicast
Neighbor Ipv4 multicast
Neighbor type
Neighbor auto-restart
Neighbor route-reflector-client
Neighbor confederation status
Neighbor remove private AS
Neighbor default originate
Neighbor maximum prefixes
Neighbor max prefixes warning
# of prefixes received
Neighbor MD5 key
Neighbor local port
Neighbor TCP window size
Graceful Restart State
Advertised Restart Interval
Forwarding State during restart
Activate IPv6 unicast
Configured IPv6 NextHop Address
Neighbor Ipv6 unicast
output definitions
Neighbor address
Neighbor autonomous system
Neighbor Admin state
Neighbor Oper state
Neighbor passive status
Neighbor name
Neighbor local address
Neighbor EBGP multihop
OmniSwitch CLI Reference Guide
= 0.0.0.1,
= 1,
= enabled,
= connect,
= disabled,
= peer(0.0.0.1),
= vlan-215,
= enabled,
= disabled,
= enabled,
= enabled,
= disabled,
= internal,
= enabled,
= disabled,
= disabled,
= disabled,
= disabled,
= 5000,
= enabled,
= 0,
= <none>,
= 0,
= 32768
= None,
= 0s,
= NotPreserved,
= enabled,
= ::,
= advertised
The IP address for this BGP peer. Assign this address through the
bgp neighbor command.
The autonomous system to which this peer belongs. A peer's AS num-
ber is assigned through the
Indicates whether this peer has been enabled or disabled through the
bgp neighbor status
The current BGP state for this peer. Possible states are idle, connect,
active, opensent, openconfirm, and established.
Indicates whether the local BGP speaker is "passive" (i.e., waiting for
this peer to initiate a session). This value is configured through the
bgp neighbor passive
The name assigned to this peer through the
tion command.
The interface assigned to this peer. This value is configured through
the ip bgp neighbor update-source
Indicates whether BGP multi-hop support is enabled or disabled. This
supports allows external BGP peers to communicate with each other
even when they are not directly connected. This value is configured
through the ip bgp neighbor ebgp-multihop
June 2012
ip bgp neighbor remote-as
command.
command.
ip bgp neighbor descrip-
command.
command.
ip
command.
ip
ip
page 25-169