Ip Bgp Network Local-Preference - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip bgp network local-preference

Defines the local preference value for a route generated by the ip bgp network command. This value will
override the default local preference value; it is used when announcing this network to internal peers.
ip bgp network network_address ip_mask local-preference value
no ip bgp network network_address ip_mask local-preference value
Syntax Definitions
network_address
ip_mask
value
Defaults
parameter
value
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to return the local preference of the specified network to its default
setting.
•
You can specify that this route use the default local preference value for the AS by specifying zero (0).
In this case the local preference for this route will take the default local preference value set for this AS
(defined in the ip bgp default local-preference
Examples
-> ip bgp network 172.22.2.115 255.255.255.0 local-preference 600
-> no ip bgp network 172.22.2.115 255.255.255.0 local-preference 600
Release History
Release 6.1; command was introduced.
Related Commands
ip bgp network
ip bgp default local-preference
page 25-50
A 32-bit IP address.
A 32-bit subnet mask that determines how many bits of the network
address denote the network number.
The local preference attribute value. The valid range is 0–4294967295.
default
0
command).
Creates or deletes a BGP network.
Sets the default local preference for this AS.
OmniSwitch CLI Reference Guide
BGP Commands
June 2012