Chapter 32 Qos Commands - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Alcatel-Lucent's QoS software provides a way to manipulate flows coming through the switch based on
user-configured policies. The flow manipulation (generally referred to as Quality of Service or QoS) may
be as simple as allowing/denying traffic, or as complicated as remapping 802.1p bits from a Layer 2
network to ToS values in a Layer 3 network.
This chapter provides information about configuring QoS global and port parameters through the
Command Line Interface (CLI). Refer to
commands used to configure QoS policy rules.
MIB information for the QoS commands is as follows:
Filename: alcatelIND1Qos.mib
Module ALCATEL-IND1-QoS-MIB
Important Note. Some of the commands listed here are not currently supported on one or more plat-
forms. See command descriptions in this chapter and check release notes for information about commands
that are not supported.
OmniSwitch CLI Reference Guide
32 QoS Commands
Chapter 33, "QoS Policy Commands,"
June 2012
for information about
page 32-1