PIM Commands
ip pim rp-mapping-notification-period
Specifies the minimum time that must elapse between the PIM RP mapping notifications originated by the
router.
ip pim rp-mapping-notification-period seconds
Syntax Definitions
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
The default value of 65535 represents an infinite time. The RP mapping notifications are never sent in
case of infinite time.
•
This value is used with both IPv4 and IPv6 PIM.
•
This command is supported only in the sparse mode.
Examples
-> ip pim rp-mapping-notification-period 100
Release History
Release 6.3.1; command was introduced.
Related Commands
show ip pim notifications
MIB Objects
alaPim
alaPimRPMappingNotificationPeriod
OmniSwitch CLI Reference Guide
Specifies the minimum time value that must elapse between RP
mapping notifications, in seconds (0–65535).
default
65535
Displays the configuration of the configured notification periods as
well as information on the events triggering the notifications.
June 2012
page 30-35