DVMRP Commands
ip dvmrp route-timeout
Configures the route expiration timeout value. The route expiration timeout value specifies how long the
switch will wait before aging out a route. When the route expiration timeout expires, the route is adver-
tised as being in holddown until either its activity resumes or it is deleted from the route table.
ip dvmrp route-timeout seconds
Syntax Definitions
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
N/A
Examples
-> ip dvmrp route-timeout 140
Release History
Release 6.1; command was introduced.
Related Commands
ip dvmrp route-holddown
show ip dvmrp
MIB Objects
alaDvmrpGlobalConfig
alaDvmrpRouteExpirationTimeout
OmniSwitch CLI Reference Guide
Specifies the timeout value, in seconds (20–4000).
default
140
Configures the time during which DVMRP routes are kept in a hold
down state.
Displays the global DVMRP parameters.
June 2012
page 29-15