Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2187

QoS Commands
•
The servicing mode only applies to destination (egress) ports because this is where traffic shaping
occurs. Even though the qos port servicing mode and qos default servicing mode commands are
allowed on source (ingress) ports, they do not affect traffic on these ports.
•
Once the qos port servicing mode command is used on a port, this same command is required to make
any additional mode changes for that port. If the port is changed back to the default servicing mode,
however, this restriction is removed and the qos default servicing mode command is also allowed on
the port.
Examples
-> qos port 3/1 servicing mode strict-priority
-> qos port 3/3 servicing mode wrr 1 2 3 4 5 6 7 8
-> qos port 3/4 servicing mode drr 10 11 12 13 14 15 16 17
-> qos port 3/2 servicing mode default
Release History
Release 6.1; command was introduced.
Release 6.1.1; wrr and drr parameters added.
Release 6.3.1; priority-wrr parameter deprecated.
Related Commands
qos apply
qos default servicing mode
show qos queue
MIB Objects
alaQoSPortTable
alaQoSPortServicingMode
alaQosPortQ0PriorityWeight
alaQosPortQ1PriorityWeight
alaQosPortQ2PriorityWeight
alaQosPortQ3PriorityWeight
alaQosPortQ4PriorityWeight
alaQosPortQ5PriorityWeight
alaQosPortQ6PriorityWeight
alaQosPortQ7PriorityWeight
OmniSwitch CLI Reference Guide
Applies configured QoS and policy settings to the current configuration.
Configures the default servicing mode for all switch ports.
Displays information for all QoS queues.
June 2012 page 32-49