Show Ip Isis Adjacency - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip isis adjacency

Displays information about IS-IS adjacent routers.
show ip isis adjacency [{system-id nbr_sys_id | interface interface_name}] [detail]
Syntax Definitions
nbr_sys_id
interface_name
detail
Defaults
By default adjacency information for all the neighbor routers are displayed.
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
Use the nbr_sys_id or interface_name parameter with this command to view the adjacency information for
a specific neighbor.
Examples
-> show ip isis adjacency
=================================================================================
ISIS Adjacency
==================================================================================
System ID
----------------------------------------------------------------------------------
1720.2116.0051
1720.2116.0051
1720.2116.0051
1720.2116.0051
----------------------------------------------------------------------------------
Adjacency : 4
==================================================================================
output definitions
System ID
Type
State
Hold
Interface
page 24-34
The system ID of the neighbor router.
The name of the IS-IS interface.
Indicates that the output is displayed in a detailed manner.
Type State Hold
L2 UP
L1 UP
L1 UP
L2 UP
The system ID of the adjacent router. The system ID is a fixed size, six
octet field in the NSAP. In an IS-IS routing domain, each router is iden-
tified by a 6-octet hexadecimal system ID.
The level (LI, L2, or L1/L2) of the adjacent router.
The state of the adjacent router (Up or Down).
The Hold time of the adjacent router.
The interface name of the adjacent router.
Interface
8 vlan2
8 vlan2
8 vlan3
8 vlan3
OmniSwitch CLI Reference Guide
IS-IS Commands
Host-name
kite-2
kite-2
kite-2
kite-2
June 2012