Ip Bgp Neighbor Route-Reflector-Client - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

BGP Commands

ip bgp neighbor route-reflector-client

Configures this peer as a client to the local route reflector.
ip bgp neighbor ip_address route-reflector-client
no ip bgp neighbor ip_address route-reflector-client
Syntax Definitions
ip_address
Defaults
This command is disabled by default.
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to remove this peer as a client to the local route reflector.
•
This command configures this peer as one of the clients to the local route reflector.
•
All of the peers configured using this command become part of the client group. The remaining peers
are members of the non-client group for the local route reflector.
•
When route reflection is configured all of the internal BGP speakers in an autonomous system need not
be fully meshed. The route reflector take responsibility for passing internal BGP-learned routes to its
peers.
Examples
-> ip bgp neighbor 172.22.2.115 route-reflector-client
-> no ip bgp neighbor 172.22.2.115 route-reflector-client
Release History
Release 6.1; command was introduced.
Related Commands
ip bgp client-to-client reflection
MIB Objects
alaBgpPeerTable
alaBgpPeerAddr
alaBgpPeerClientStatus
OmniSwitch CLI Reference Guide
32-bit IP address of the neighbor.
Configures the local BGP speaker as a route reflector
June 2012 page 25-59