Qos Port Q Minbw Maxbw - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

qos port q minbw maxbw

Configures a minimum and maximum bandwidth for each of the 8 COS egress queues on the specified
port.
qos port slot/port qn {minbw | maxbw} kbps
qos port slot/port no qn {minbw | maxbw} kbps
Syntax Definitions
slot/port
n
kbps
Defaults
By default the minimum bandwidth value for each queue is set to zero (best effort), and the maximum
bandwidth value for each queue is set to zero (port speed).
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to return the minimum or maximum bandwidth value for the speci-
fied queue to the default value (zero).
•
Note that configuring the minimum and maximum bandwidth for the same queue is allowed on the
same command line (see the "Examples" section).
•
Configuring the bandwidth values for different queues requires a separate command for each queue.
Examples
-> qos port 1/3 q0 minbw 10 q0 maxbw 100
-> qos port 1/3 q1 minbw 100
-> qos port 1/3 q1 maxbw 10g
-> qos port 2/1 q7 minbw 5k q7 maxbw 50k
-> qos port 1/3 no q1 minbw
-> qos port 1/3 no q1 maxbw
Release History
Release 6.1.1; command was introduced.
page 32-50
The slot/port on which the COS min/max bandwidth is configured.
The number of the queue for the specified port. Range is 1 to 8.
The minimum or maximum bandwidth value (in Kbits per second). The
value may be entered as an integer (for example, 10000) or with abbre-
viated units (for example, 10k, 10m, 10g, or 10t). If the value is entered
in bits per second, the switch rounds the value up to the nearest thou-
sand.
OmniSwitch CLI Reference Guide
QoS Commands
June 2012