Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2103

PIM Commands
Elected BSR
Timer
output definitions
Scope
CBSR Address
Status
CBSR Priority
Hash Mask Length
Elected BSR
Timer
Release History
Release 6.3.1; command was introduced.
Release 6.3.4; scope parameter was added.
Related Commands
ipv6 pim cbsr
MIB Objects
pimBsrCandidateBSRTable
pimBsrCandidateBSRZoneIndex
pimBsrCandidateBSRAddress
pimBsrCandidateBSRPriority
pimBsrCandidateBSRHashMaskLength
pimBsrCandidateBSRElectedBSR
pimBsrCandidateBSRBootstrapTimer
pimBsrCandidateBSRStatus
OmniSwitch CLI Reference Guide
= False,
= 00h:00m:00s
IPv6 scope value that ranges from 3-15. It is used to define Candidate
BSR information associated with a particular scope zone.
An IPv6 unicast address that the local router uses to advertise itself as a
Candidate-BSR for PIM IPv6.
The current status of this entry. The status is shown as enabled only if
the IPv6 PIM-SM is globally enabled and the IPv6 PIM interface is
enabled.
The priority value for the local router as a Candidate-BSR. The higher
the value, the higher the priority.
The hash mask length that is advertised in the Bootstrap messages (the
length of the mask is used in the hash function when computing the
Rendezvous Point (RP) for an IPv6 multicast group).
Specifies whether the local router is the elected BSR for PIM IPv6.
The time that is remaining before the local router originates the next
Bootstrap message. This value is zero if this router is not the elected
BSR.
Configures the Candidate-BSR information that is used in the Boot-
strap messages.
June 2012 page 30-115