PIM Commands
ip pim sparse status
Globally enables or disables PIM-SM protocol on the switch.
ip pim sparse status {enable | disable}
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command must be set to enable before PIM-SM can run on the switch. In addition, the ip load
pim command must be executed. Refer to
•
The advanced routing image must be loaded to flash before the feature will start to work on the switch.
Examples
-> ip pim sparse status enable
-> ip pim sparse status disable
Release History
Release 6.1.1; command was introduced.
Related Commands
ip pim interface
ip load pim
show ip pim sparse
MIB Objects
alaPimsmGlobalConfig
alaPimsmAdminStatus
OmniSwitch CLI Reference Guide
Globally enables PIM-SM on the switch.
Globally disables PIM-SM on the switch.
default
disable
page 30-3
Enables or disables the PIM protocol on a specific interface.
Dynamically loads PIM to memory.
Displays the status of the various global parameters for the PIM
sparse mode.
June 2012
for more information.
page 30-5