Ip Ospf Interface Dead-Interval - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip ospf interface dead-interval

Configures the OSPF interface dead interval.
ip ospf interface {interface_name} dead-interval seconds
Syntax Definitions
interface_name
seconds
Defaults
parameter
seconds
(broadcast and point-to-point)
seconds
(NBMA and point-to-multi-
point)
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This is the interval, in seconds, after which a neighbor on this interface is considered dead if no hello
packets have been received from this neighbor.
•
This interval should be greater than the hello interval or the multiple of the hello interval.
Examples
-> ip ospf interface vlan-101 dead-interval 50
Release History
Release 6.1; command was introduced.
Release 6.2.1; ip_address parameter deprecated.
Related Commands
ip ospf interface hello-interval
show ip ospf interface
MIB Objects
ospfIfTable
ospfIfRtrDeadInterval
page 22-32
The name of the interface.
The dead interval, in seconds. The valid range is 1–65535.
default
40
120
Configures the OSPF interface hello interval.
Displays the status and statistics of an OSPF interface.
OmniSwitch CLI Reference Guide
OSPF Commands
June 2012