Show Ip Dvmrp Tunnel - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip dvmrp tunnel

Displays DVMRP tunnel entries.
show ip dvmrp tunnel [local_address remote_address]
Syntax Definitions
local_address
remote_mask
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
If optional local and remote IP address information is not specified, entire DVMRP Tunnels table is
displayed.
•
The local IP address of the tunnel must match the IP address of an existing DVMRP-enabled IP inter-
face.
Examples
-> show ip dvmrp tunnel
Interface Name
-------------------+-----------------+-----------------+-----+----------
vlan-2
output definitions
Interface Name
Local Address
Remote Address
page 29-38
The IP address of a particular local router interface. The local router
interface IP address is an identifier for the local end of the DVMRP
tunnel.
The IP address of a particular remote router interface. The remote router
interface IP address is an identifier for the remote end of the DVMRP
tunnel.
Local Address Remote Address
143.209.92.203 12.0.0.1
The interface name. This field is only displayed on OmniSwitch 6850E
switch.
The 32-bit local IP address for the DVMRP tunnel.
The 32-bit remote IP address for the DVMRP tunnel.
TTL Status
255 Enabled
OmniSwitch CLI Reference Guide
DVMRP Commands
June 2012