Show Ipv6 Pim Group-Map - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ipv6 pim group-map

Displays the IPv6 PIM group mapping table.
show ipv6 pim group-map [bsr | static-rp | ssm | dense]
Syntax Definitions
N/A
Defaults
If the keywords bsr, static-rp, ssm, or dense are included in the command line, then only the entries that
were created by the specified origin are displayed.
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
If static RP configuration is being used, this information is obtained from those static RP addresses that
are defined via the
set are reachable, they will be added to the group mapping table.
•
If the IPv6 multicast groups are mapped to the mode DM or SSM, then the entries created by local
SSM address range configuration using the
address range configuration using the
•
If the Bootstrap mechanism is being used, this information is obtained from received Candidate-RP
advertisements (when the local router is the BSR; when the local router is not the BSR, this informa-
tion is obtained from received Bootstrap messages).
Examples
-> show ipv6 pim group-map
Origin Group Address/Pref Length
---------+---------------------------+-------------+-----+-----------
BSR ff00::/8
BSR ff00::/8
SSM ff33::/32
-> show ipv6 pim group-map bsr
Origin Group Address/Pref Length
---------+---------------------------+-------------+-----+-----------
BSR ff00::/8
BSR ff00::/8
-> show ipv6 pim group-map ssm
Origin Group Address/Pref Length
---------+---------------------------+-------------+-----+-----------
page 30-110
ipv6 pim static-rp command. As long as the RP addresses defined in the static RP
ipv6 pim ssm group
ipv6 pim dense group
command and local Dense Mode
command are displayed.
RP Address Mode
3000::11 asm
4000::7 asm
ssm
RP Address Mode
3000::11 asm
4000::7 asm
RP Address Mode
OmniSwitch CLI Reference Guide
PIM Commands
Precedence
192
192
Precedence
192
192
Precedence
June 2012