Show Ip Bgp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

BGP Commands

show ip bgp

Displays the current global settings for the local BGP speaker.
show ip bgp
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
Most of the parameters in this display can be altered through BGP global commands. See the output defi-
nitions below for references to the CLI commands used to configure individual parameters.
Examples
-> show ip bgp
Admin Status
Operational Status
Autonomous system Number
BGP Router Id
Confederation Id
IGP Synchronization Status
Minimum AS origin interval (seconds) = 15,
Default Local Preference
Route Reflection
Cluster Id
Missing MED Status
Aspath Comparison
Always Compare MED
Fast External Fail Over
Log Neighbor Changes
Multi path
Graceful Restart
Graceful Restart Status
Configured Graceful Restart Interval = 90s,
IPv4 Unicast
IPv6 Unicast
output definitions
Admin Status
Operational Status
OmniSwitch CLI Reference Guide
= disabled,
= down,
= 1,
= 128.0.1.4,
= 0,
= disabled,
= 100,
= disabled,
= 0.0.0.0,
= Best,
= enabled,
= disabled,
= disabled,
= disabled,
= disabled,
= enabled,
= Not Restarting,
= enabled,
= disabled
Indicates whether the BGP protocol has been enabled or disabled
through the ip bgp status
Indicates if the local BGP speaker is actively participating in BGP
messages, update, routing advertisements.
June 2012
command.
page 25-149