Show Ipv6 Ospf Lsdb - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ipv6 ospf lsdb

Displays Link State Advertisements (LSAs) in the Link State Database (LSDB) associated with each area.
show ipv6 ospf lsdb [area area_id] [rtr | net | netsum | asbrsum] [linkstate-id ls_id] [router-id
router_id]
Syntax Definitions
area_id
rtr
net
netsum
asbrsum
ls_id
router_id
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is used to display the LSDB of the OSPF router. It can be used for OSPF debugging,
specifically to narrow down sections of an area to determine which sections are receiving the specified
LSAs. You can specify the parameters of only the area LSDB using the optional command parameters.
•
You can view LSAs by specifying either a link state identifier or a router identifier. However, when
specifying a router ID, you also need to supply a valid link state ID.
page 23-32
A unique 32-bit value in IP address format.
Specifies router LSAs.
Specifies network LSAs.
Specifies network summary LSAs.
Specifies Autonomous System Border Router summary LSAs.
The Link state ID. The ID is a unique 32-bit value, such as an IP
address. This number is used as a record in the link state database.
The Router ID. The ID is a unique 32-bit value such as an IP address.
OmniSwitch CLI Reference Guide
OSPFv3 Commands
June 2012