Show Ipv6 Pim Sgroute - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ipv6 pim sgroute

Displays all (S,G) state that the IPv6 PIM has.
show ipv6 pim sgroute [source_address group_address]
Syntax Definitions
source_address
group_address
Defaults
By default, entire (S,G) routing table is displayed. To view the detailed information for a particular (S,G)
entry, use the source_address and group_address associated with that entry.
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
When the source_address and group_address is specified in the command line, the detailed informa-
tion displayed also includes the detailed state of every outgoing interface.
•
If an IPv6 address is not specified, the current PIM status for all multicast route entries are displayed.
Examples
-> show ipv6 pim sgroute
Legend: Flags: D = Dense, S = Sparse, s = SSM Group,
L = Local, R = RPT, T = SPT, F = Register,
P = Pruned, O = Originator
Total 1 (S,G)
Source Address
---------------------+---------------------+----------------+-----------+------
8ffe::3
-> show ipv6 pim sgroute 8ffe::3 ff0e::7
(8ffe::3,ff0e::7)
UpTime
PIM Mode
Upstream Join State
Upstream RPT State
Upstream Join Timer
Upstream Neighbor
SPT Bit
DR Register State
DR Register Stop Timer
Interface Specific State:
page 30-122
The IPv6 address for a specific multicast source.
A IPv6 multicast address.
Group Address
ff0e::7
= 00h:01m:40s
= ASM,
= Not Joined,
= Not Pruned,
= 00h:00m:00s,
= none,
= False,
= No Info,
= 00h:00m:00s,
RPF Interface UpTime
00h:01m:34s
OmniSwitch CLI Reference Guide
PIM Commands
Flags
SR
June 2012