Show Ip Dvmrp Neighbor - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip dvmrp neighbor

Displays the DVMRP neighbor table. The DVMRP neighbor table displays either all neighboring DVMRP
routers, or a specified neighboring DVMRP router.
show ip dvmrp neighbor [ip_address]
Syntax Definitions
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
If a neighbor IP address is not specified, the entire DVMRP Neighbor Table is displayed.
Examples
-> show ip dvmrp neighbor
Neighbor Address
----------------+-------------+-----------+-----------+----------+------+-------
143.209.92.214
output definitions
Neighbor Address
Itnf Name
Uptime
Expires
GenID
Version
State
Release History
Release 6.1; command was introduced.
page 29-30
Specifies a particular IP address for a neighboring DVMRP router.
Intf Name Uptime
vlan-2 00h:09m:12s 00h:00m:06s 546947509 3.255
The 32-bit IP address of the DVMRP neighbor's router interface.
The interface name of the neighbor's router.
The amount of time the neighbor has been running, displayed in hours,
minutes, and seconds.
The amount of time remaining before the neighbor expires, displayed in
hours, minutes, and seconds.
The generation ID for the DVMRP neighbor. This value is used by
neighboring routers to detect whether the DVMRP routing table should
be resent.
The DVMRP version number for the neighbor.
The current state of the DVMRP neighbor. Options include active and
down.
Expires GenID
OmniSwitch CLI Reference Guide
DVMRP Commands
Vers State
active
June 2012