Ip Pim State-Refresh-Ttl - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip pim state-refresh-ttl

Sets the Time to Live to be used in a router's originated State Refresh messages if the data packet's Time
to Live is not recorded.
ip pim state-refresh- ttl num
Syntax Definitions
num
Defaults
parameter
num
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is supported only in the dense mode.
•
This value is used with both IPv4 and IPv6 PIM-DM.
Examples
-> ip pim state-refresh-ttl 122
Release History
Release 6.1.1; command was introduced.
Related Commands
ip pim interface
ipv6 pim interface
show ip pim dense
show ipv6 pim dense
MIB Objects
alaPimdmGlobalConfig
alaPimdmStateRefreshTimeToLive
page 30-28
The Time to Live to be used. Values may range from 0 to 255.
default
16
Enables or disables the PIM protocol on a specific interface.
Enables IPv6 PIM and configures the statistics.
Displays the status of the various global parameters for the PIM
dense mode.
Displays the status of the various global parameters for the IPv6
PIM dense mode.
OmniSwitch CLI Reference Guide
PIM Commands
June 2012