BGP Commands
ip bgp neighbor conn-retry-interval
The interval, in seconds, between BGP retries to set up a connection via the transport protocol with
another peer. In the connect state, BGP tries to set up a connection with a remote peer. If the connec-
tion fails, then the connect retry interval is started. Once this interval elapses, BGP retries setting up
the connection.
ip bgp neighbor ip_address conn-retry-interval seconds
Syntax Definitions
ip_address
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
The time interval is started when a connection to a peer is lost.
•
Other BGP peers may automatically attempt to restart a connection with this peer if they have config-
ured automatic peer session restart (using the
•
You must restart the peer (using the
before the new connection retry interval takes effect.
•
Entering this command without the seconds variable resets the variable to its default value.
Examples
-> ip bgp neighbor 172.22.2.115 connect-interval 60
-> ip bgp neighbor 172.22.2.115 connect-interval
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
A 32-bit IP address for the neighbor.
The time interval (in seconds) between retries. The valid range is
0–65535.
default
120
ip bgp neighbor auto-restart
ip bgp neighbor clear
June 2012
command).
command) after issuing this command
page 25-63